Categories: Relief Aid Products
Water distribution kit (tap stand) to be used with collapsible water
tanks. The stand is made of hot dipped galvanized steel pipes or hot
rolled galvanized steel sections. All pipes should be threaded as per
ISO 7 (the thread cutting oil must be non toxic type), and must be able
to withstand rough handling during use.
Four sturdy legs (or two "A" frames), each leg fitted with a drilled plate for holding down purposes.
1 x 1 ½" (40 mm) male threaded riser pipe.
1 Female threaded 2"-1 ½" (50 mm-40 mm) junction tee with closing(for
the connection to the storage tank or to other tap stands).
2 male threaded Guillemin or Storz couplings.
1 central, horizontal distribution pipe.
6 x Male threaded tap pipes welded to the central distribution pipe.
7 x Female threaded ¾" (20 mm) self-closing taps. Minimum discharge rate
per tap: 10 liters per minute at one meter head, operation range: Up to
4 bars.
2 x ¾" (20 mm) female threaded caps (for closing in case of repair of repair of faulty taps).
4 rolls of teflon tape (12 mm x 12 meters each).
4 plated pegs for fixing down of the tap stand, each 30 cm long, minimum diameter 12 mm.
1 piece of wire netting for concrete slab, 0.9 x 1.5 meters
each.(Smaller pieces could be supplied to minimize the shipping volume,
provided that the necessary overlapping of the net reinforcement is
taken into consideration).
More products related to Relief Water Distribution Kit 6 Taps