Relief Handpump AFRIDEV Variant 1 Package 30m

Shallow well hand pump, complete, specifications as per IS:8035/1999 (or later revision).
This suction type hand pump is used for lifting water from a depth not exceeding 7-8m
The principal components of the pump are:
1 x Pump Body, cast iron (barrel)
1 x Pump head/cover (w/fulcrum)
1 x fulcrum and rod pin
1 x head pin
1 x Pump handle
1 x Pump baseplate (flapper valve and weight)
1 x flapper type valve
1 x Plunger rod (assembly with bucket)
1 x upper plunger disc
1 x lower plunger disc
1 x spacer for piston seals
1 x washer for bucket
9 meters of rising main, (3x3m) pipe, 1 ½ inch
2 x FRP Rod arrangement, 3 meters length, with couplers, as per drawings A 5889 and A 5896 (ref. SKAT-RWSN Afridev Specifications Rev. 5:2007)

The pump set is supplied with following Fast Moving spares for shallow well hand pumps, as listed below:
1 x Rubber gasket
4 x Sprint washer for M 12 Bolt
4 x Hex Bolt M 12 x M 1.75-65mm long
4 x Circlip for 16 outer dial shaft
2 x Fulcrum pin
2 x Plunger pin
1 x Plunger rod
2 x Cup seal
2 x Hardened steel bush
1 x Check valve